The LEDs look beautiful and the build quality feels very premium, I like how you can use a hex screwdriver to twist the actual Bulb section to adjust your beam spread but luckily with my "correct" lock in position the spread was fine. I have reflector housings instead of projector lamps but I haven't been high beamed or signaled by anyone, as the beam spread seems to be quite good for my car.
This would have a higher score if not for a pretty big issue with the fitting. I confirmed that this is the correct bulb size(9006) for my 2007 Honda Accord SE, but the fitment ring hardly fits as it is incredibly loose to the point that they can possibly move while driving altering the beam spread. I haven't had the misfortune of the bulb completely falling out of the housing but it's loose to the point that I wouldn't be surprised if it did. When compared them to my Sylverstars ZXE Halogens, the ring's 3 tabs seem to be too short(about half the length) allowing the LED bulb to just barely stay on. At the moment I've been jury rigging a solution with some electrical tape off only one side of the heatsink to keep the bulbs in place but it's not an elegant nor great solution. I'm not sure if this is the case for all cars but I'm definitely not the only person afflicted so hope for the best with your model.
Updated with pictures!